सीएनसी मशीनिंग केंद्र

Holzfraese HP 1890

Used machine

Year of manufacture: 2019

Hnsdpfx Afow Nadyowon
Only 110 operating hours!

Equipment and technical data:

X = 1800 mm
Y = 900 mm
Z = 80 mm

Made from 18 mm Koskisen panels, consisting of a milling table (X-axis), a gantry (Y-axis), and a Z-axis.

Milling bed in 19 mm MDF used as a sacrificial plate with guide rails and T-slot nuts for clamping.

Subframe with reinforcements, filled with polymer concrete, prepared for transport with pallet truck or forklift.

Mechanical set consisting of profile guides including guide carriages, as well as ball screws 2010 and 1605 for all axes.

Shaft couplings and high-performance grease for lubricating the individual carriages, as well as energy chains including connection sets.

Control set consisting of a Triple Beast, for controlling 3 axes, with Ethernet interface.

Leadshine driver for the fourth motor. Four stepper motors, 5.0A, 3Nm with motor cables, as well as power supply unit with 48V, 6.7A, LED board for breakout board, ribbon cable and proximity sensors, small parts like single-core wires, wire end sleeves, control cables, heat shrink tubing, and cable lugs.

Fully installed in an aluminum enclosure including electrical wiring and emergency stop.

21.5 inch built-in monitor, including mini PC with Windows 7, CAD software Rhino 5.0, G-code generator Estlcam, control software Beamicon2, as well as mouse and keyboard, pre-installed in an ergonomic control desk.

Tool length sensor for determining the length and updating the active zero offset.

Special equipment:

High-frequency spindle with 2.2 kW, including locknut, frequency inverter, line filter, braking resistor, and collet set.

PC with 8 GB RAM and AMD processor

CAD software Rhino 5.0 for creating both simple 2D data and 3D solid models

Availability: short-term
Location: Flörsheim

इस विज्ञापन का स्वचालित रूप से अनुवाद किया गया है। अनुवाद में त्रुटियाँ संभव हैं।