ब्रॉचिंग मशीन

Rausch RS3/800

Manufacturer: Rausch (Haan/ Rhld)
Model: RS 3 G/800
Machine No.: 2968/424
Year of manufacture: 1970
Weight: 370kg
Overhaul: 8/2025 by Wiemers AG
Our Ref. / Machine No.: WAG 787

General / Technical Data:
Unused, overhauled mechanical vertical broaching machine by Rausch
Pulling force: 3,000kg (30kN)
Broaching speeds: 3m/min and 6m/min
Return speed: 3m/min
Maximum stroke: 800mm
Maximum tool length: 1,000mm
Table size / working surface: 340mm x 220mm / 430mm x 310mm
Table opening: Ø 90mm for standard broaching mandrels
Workpiece diameter: unlimited (without spray guard cabin)
Dimensions (h x w x d): 1,950mm x 820mm x 900mm (h = table height from floor without attachments)
Motor: 3.5kW
Power supply: 400 Volt / 50 Hz

Accessories / Special Features:

- Modified drive system with geared motor and toothed belt drive
Bwjdeytvyxopfx An Eeu
- 2 broaching speeds: 3m/min & 6m/min
- External stroke adjustment, cross-machine reproducible tool length adjustment system
- Integrated coolant unit with check valve and drain cock, including selector switch for automatic operation (does not automatically switch in swivel mode)
- Patented coolant/lubricant swivel system
- Three-sided enclosed, front-open spray guard cabin (no external operator panel)
- Machine enclosure below the safety door with chip guard and tool storage area
- Electrical cabling within steel protective conduits
- Electrical jaw monitoring (tool removal control to prevent unintended retraction of the pull bridge)
- Safety door with integrated emergency stop function
- Control panel made from stainless steel sheet with permanent marking
- 4 central lubrication points for the trapezoidal spindle drive
- Machine documentation

Remarks:

The machine is fully overhauled, with the frame completely refurbished.
The following wear parts have been replaced:

- New trapezoidal spindles and spindle nuts made from cast wear-resistant bronze
- All bearings and seals replaced
- Central drive shaft is new
- Coolant system (pump, check valve and drain cock), including coolant/lubricant swivel system, is new
- Jaws are new (pull bridge additionally reinforced)
- A switchable jaw monitoring system has been installed (additional safety for operators and to prevent tool breakage)
- A safety door with interlock has been installed instead of the rubber reach-in protection
- Tool length adjustment system relocated outside the machine compartment
- Additional limit switches installed
- Complete electrical system (control cabinet) with Siemens components is new
- Control panel made of stainless steel with durable labeling
- New geared drive motor (SEW) with toothed belt drive
- Machine has been repainted with 2-component structural paint

The machine is stored at our warehouse and can be inspected under power.

इस विज्ञापन का स्वचालित रूप से अनुवाद किया गया है। अनुवाद में त्रुटियाँ संभव हैं।